|
 APSCO PREFABS is an ISO 9001:2000 certified Company and is awaiting the prestigious TS:16949 certification. The company has been manufacturing and supplying Auto & Tractor parts since 1992. The company’s core competency lies in Metal sheet and plate stampings and also specializes in fabrication and supply of fully assembled modules which include machined components .A strong focus, as an Original Equipment Manufacturer (OEM), has enabled the company to offer a wide product range to varied customers.
 APSCO Prefabs has in-house Design & Development and Tool Room facilities. It undertakes complete turnkey design and development of new products to the complete satisfaction of esteemed customers. All our products are designed and manufactured in compliance with highest international quality standards maintained under our Quality Management System. Design, Development and Maintenance of all dies, tooling, jigs and fixtures is done in-house by our trained and experienced D&D department.
The products and services offered by the company include
1. MP Hitch Block Assembly – Press work; Punching; MIG Welding
- 10 mm Plate
 16 mm Flat
- 8 mm Flat
2. Front Floor Plate Assembly 50/80HP Tractor – Press work, Punching, Spot Welding, MIG Welding
3. Floor Plate LH/RH for MG312/405/453 Tractors – Press work, Punching/Embossing, Spot Welding, MIG Welding
 MS CR Sheet in 1.6 mm
4. Pins for MP Hitch Block – Machining, MIG Welding, Drilling, Zinc Plating
5. Hand Brake Assembly – Machining, Presswork, Punching, MIG Welding, Zinc Plating
- MS CR Sheet in 1.6mm
 MS/EN8 rods Ø 6, 8, 10, 25mm
6. Engine Valve cover housing – EDD Press work, Embossing, Baked Enamel Painting, Powder Coating
7. Bonnet Assembly Parts MG312/405/453 Tractors - Press work, Punching/Embossing, Spot Welding, MIG Welding
8. Rear Registration Plate – Presswork, MIG Welding, Painting
9. Accelerator Control Assembly – Machining, Presswork, Punching, MIG Welding, Zinc Coating
- MS/EN8 Rods Ø 6, 10, 12, 25, 32mm mm
- Flats mm
- MS CR Sheet 1.6mm
The group is also working on a new, ‘Centre of Excellence’, project for product development. As part of this project the group plans to create a unique product design and development centre with a keen focus on global standards and requirements.
|
|
